Table Of Maintenances - MINARI ENGINE F1-VRFE Manuel D'utilisation

22
PERIOD
BEFORE
EVERY USE
EVERY 25 HOURS
EVERY 50 HOURS
EVERY 100 HOURS - Replacement of the cylinder gaskets
EVERY 200 HOURS - Replacement piston rings
EVERY 400 HOURS - Replacement of the crankshaft
*
To be made by authorized persons only!
WE ARE NOT RESPONSIBLE FOR MALFUNCTION OR DAMAGE CAUSED BY MAINTENANCE WORK
PROVIDED BY NOT AUTHORIZED PERSONS.
For information about the nearest authorized center, please contact us by email or phone
(see details on the last page)

TABLE OF MAINTENANCES

OPERATIONS
- Control of the tightening of the bolts and nuts of the engine and the frame
- Verify the engine mounts and exhaust mounts (silent - block)
- Belt tension control
- Check that the safety systems are intact
- Check the condition of the wiring and the connector plug
- Check the condition of the rope of the starter and the starter rim on engi-
ne with electric start.
- Check that the two joints of the exhaust are not blocked
- Check and clean the carburetor
- Verify the manual starter grafting teeth wear condition
- Check and clean the air fi lter
- Replacement of the spark plug
- Replacement of the exhaust springs
- Disassemble the two joints of the exhaust, clean and lubricate them.
- Check and clean electrical contacts and wiring
- Replacement of the starter rope (for manual starter engine)
- Replacement of the drive belt
- Replacement of all the engine and exhaust mounts (silent block)
- Check the airbox rubber sleeve wear
- Check wear conditions of clutch assemblly and clutch bell
- Replacement of the membranes of the carburetor
- Replacement of the head gaskets
- Scraping of the combustion chamber
- Clean the decompressor hole
- Replacement piston, suitable for cylinder tolerance
- Replacing the reed valvle
- Replacement of the pulley bearings
- Replacement of the clutch bel berings
- Replacement of the crankshaft bearings
- Replacement of the crankshaft oil seals