Bosch BO-51843 Instructions De Service Originales page 8

8 | English
Important information
▶ Read the safety instructions before starting any work, and only have the work steps performed by qualified personnel!
▶ Wear appropriate protective equipment, such as gloves and sealed safety goggles .
▶ Protect the vehicle from the tool coming loose from the screen .
▶ The windscreen removal cord becomes highly stressed when cutting, and there is always the possibility of the cord ripping
spontaneously . You should therefore only use the windscreen removal cord once for your own safety .
▶ The tools are not designed for the use of removal wires . The warranty is invalidated if a removal wire is used .
▶ Only use original spare parts and original windscreen removal cords .
▶ You need a powerful and adjustable cordless screwdriver with at least 18 V .
▶ Follow the vehicle manufacturer's work instructions .
1
2
3
Preparing for windscreen removal
Remove all attachment parts which you could damage by re-
moving the screen, such as windscreen wiper arms, borders,
covers, interior mirrors, sensors and their connecting cables .
Insert the awl in the bottom left-hand edge of the windscreen
from the inside towards the outside . (Fig . 1)
Fit the windscreen removal cord into the awl slit and pull the
end approx . 1 m into the vehicle's interior . Feed this end of
the windscreen removal cord between the two pulleys of
the removal device from the front . Insert the removal cord
through the shaft hole and knot it . Secure the windscreen
removal cord by turning clockwise (5–6 turns) with the Allen
key .
Position the removal device as shown in figures 2 and 3 . Now
route the windscreen removal cord around the outside of the
vehicle windscreen in a clockwise direction . Ensure that the
windscreen removal cord is on the adhesive bead between
the screen and the frame . If necessary, use the mounting
wedge to help you .
Cut the windscreen removal cord so that it overlaps the
insertion point by at least 20 cm and knot it on the fastening
hook (Fig . 2) .
Now attach the fastening hook to a suitable place in the
engine compartment . (Not the windscreen wiper shafts!)
ATTENTION: Make sure that during the removal process
the windscreen removal cord cannot damage any
appliances, cables, hoses or coverings and secure the
windscreen so that it cannot fall out.