Publicité
Les langues disponibles
Les langues disponibles
CAUTION:
1. For kneading yeast dough, always select speed 3 or lower. Using
other speed higher than speed 3 may damage the mixer.
2. Do not scrape the bowl while the stand mixer is operating.
3. The bowl and beater are designed to provide thorough mixing
without frequent scraping. Scraping the bowl once or twice during
mixing is usually sufficient.
4. Turn the stand mixer off before scraping.
5. The stand mixer may warm up during use. Under heavy load with
extended mixing time, you may not be able to comfortably touch
the top of the stand mixer, this is normal.
THERMAL PROTECTION
Your stand mixer motor is equipped with an automatic thermal
protection feature which will shut your motor off if it gets too hot. If this
occur, turn the speed selector Off, unplug the unit and allow it to cool
down. It is normal for the mixing head to become hot after prolonged
use.
USING ACCESSORY ATTACHMENT
A number of OPTIONAL accessory attachments are available for use
with your stand mixer. See the following general instructions for
assembling and removing them.
ASSEMBLING OPTIONAL FRONT POWER HUB ATTACHMENTS
1. Ensure stand mixer is turned off and the unit is unplugged.
2. Flip the hub cover up, and then press down and hold the accessory
release tab while inserting the accessory into the hub as far as it will
go.
3. Let go of the accessory release tab and rotate the attachment
slightly left and right until you hear the locking pin click into place.
4. To ensure your attachment is locked into place try pulling it out
while not pressing down on the accessory release tab.
REMOVING FRONT POWER HUB ATTACHMENTS
1. Turn stand mixer off and unplug from outlet.
2. Press the attachment lock down and hold while pulling the
accessory attachment out of the hub.
CARE AND CLEANING
Bowl and splash guard may be washed by dishwasher or using
soapy water. Dry them completely before use again.
EN-13
Publicité
