STERWINS 1000 DW-4 Notice De Montage, Utilisation Et Entretien page 178

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 4
• Do not scrape the power cord across sharp edges and ensure
FR
that it does not get pressed.
ES
4.2 INSTALLATION
PT
Assemble the different elements together according to the illustration. In case screw are necessary :
tight it with appropriate tool.
IT
EL
• Screw the pump connecting piece onto the connection nozzle.
PL
• Slide the hose clamp onto the hose.
• Slide the hose onto the pump connecting piece and secure it by means of a hose clamp
RU
Connecting the discharge hose : illustration 2.1 to 2.3
Required accessories : Connector and PVC hose
Screw the adapter clockwise onto the outlet of the pump casing. Tighten manually and sufficiently.
KZ
On the pump connection element, different hose diameters can be connected. A sufficiently large hose
diameter must be selected and the pump connecting piece must be shortened according to the grooves
so that the required particle size can be used. A large hose diameter is also recommended for smaller
UA
particle sizes to allow a high flow volume.
RO
EN
4.3 FIRST USE
Pay particular attention using the machine for the first time : focus and dedicate all your attention to this
first use.
Priming the pump : illustration 3.1 and 3.2
If the water is not pumped out after 20 seconds of starting, lower the float and lift the pump. Wait until
the pump empties of water and plunge the pump back into the water. Restart the pump.
4.4 OPERATION
Start the product : illustration 4.4
Before any use, make sure that the pump is properly primed (see chapter above)
The shorter the hose length and the larger the hose diameter,
the higher the pump capacity
CAUTION ! Always wear safety glasses and gloves during
installation.
WARNING ! Read the « SAFETY INSTRUCTION » section at the
beginning of this manual including all text under subheading
therein before using this product.
Note: The pump must be fully immersed in water. Otherwise
the pump will not prime, will not be able to operate at its
maximum flow rate and may be damaged !
178
12

Publicité

Table des Matières
loading

Table des Matières