Introduction; Certification; Warranty; Limitation Of Warranty - Pentair Raychem NGC-20-C-E Guide D'installation, D'utilisation Et De Maintenance

1. INTRODUCTION

1.1 Certification

1.2 Warranty

1.3 Limitation of warranty

1.4 Exclusive remedies

1.5 Statement of compliance

INDUSTRIAL HEAT TRACING SOLUTIONS
Please read all instructional literature carefully and thoroughly before starting. Refer to the inside
front cover for the listing of Liabilities and Warranties.
NOTICE: The information contained in this document is subject to change without notice.
Please read these Operating Instructions before Commissioning the instrument. Keep the
operating instructions in a place which is accessible to all users at all times. Please assist
us to improve these operating instructions, where necessary. We are always grateful for your
suggestions.
Should any difficulties arise during start-up, you are asked not to carry out any unauthorized
manipulations on the instrument as this could affect your warranty rights! Please contact the
nearest Pentair subsidiary or the head office.
If any servicing is required, the instrument must be returned to the head office.
Pentair certifies that this product met its published specifications at the time of shipment from
the Factory.
This Pentair product is warranted against defects in material and workmanship for a period
of 12 months from the date of installation or 30 months maximum from the date of shipment,
whichever occurs first. During the warranty period, Pentair will, at its option, either repair or
replace products that prove to be defective.
For warranty service or repair, this product must be returned to a service facility designated
by Pentair. The Buyer shall prepay shipping charges to Pentair and Pentair shall pay shipping
charges to return the product to the Buyer. However, the Buyer shall pay all shipping charges,
duties, and taxes for products returned to Pentair from another country.
Pentair warrants that the software and firmware designated by Pentair for use with a product
will execute its programming instructions properly when installed on that product. Pentair does
not warrant that the operation of the hardware, or software, or firmware will be uninterrupted or
error-free.
The foregoing warranty shall not apply to defects resulting from improper or inadequate
maintenance by the Buyer, Buyer-supplied software or interfacing, unauthorized modification or
misuse, operation outside of the specifications for the product, or improper installation.
NO OTHER WARRANTY IS EXPRESSED OR IMPLIED. PENTAIR DISCLAIMS THE IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
THE REMEDIES PROVIDED HEREIN ARE THE BUYER'S SOLE AND EXCLUSIVE REMEDIES.
PENTAIR SHALL NOT BE LIABLE FOR ANY DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES, WHETHER BASED ON CONTRACT, TORT, OR ANY OTHER LEGAL
THEORY.
This equipment has been tested and found to comply with the low voltage directive 2006/95/EC
and the electromagnetic compatibility directive 2004/108/EC. These limits are defined to provide
reasonable protection against harmful interference in a residential installation (technical data
mentions industrial application). This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorientate or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
ML-RaychemNGC20CLE-IM-INSTALL130 Rev8 4 / 95