Buttons For Setting The End Positions - GF Piping Systems EA15 Mode D'emploi

Design and function

5.3.3 Buttons for setting the end positions

Buttons for setting the end positions inside the actuator
The following table describes the functions of buttons shown above:
Button Adjustment mode
("SET" button pressed for ~3 s)
SET Press the button, until the color of
the LED of which the assigned
position is to be changed lights up
(e. g. green – CLOSE)
STORE Saving the position moved to
CCW Moving counterclockwise
CW Moving clockwise
The following table describes the functions of button combinations:
Button Function
combination
(press ~3s)
SET + CCW LED color assignment
SET + CW Factory reset
42
Error mode
LED flashes yellow
Acknowledge
the error (instead
of disconnecting
the power supply)
Action
Inverting colors
Actuator will be set to the values pre-set
at the factory; all positions will be deleted
Instruction manual