Usb Playback; Radio Reception; Remote Control - Yamaha TSX-130 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28

USB playback

Problem
MP3/WMA file in the USB
device does not play.
"USB Over Current"
appears on the front panel
display.

Radio reception

Problem
The preset selecting
function does not work.
Too much noise during
stereo broadcast.
Even with an outdoor
antenna, radio wave
reception is weak. (Sound is
distorted.)

Remote control

Problem
The remote control does not
work properly.
Cause
The USB device is not recognized.
If the solutions above do not resolve
the problem, the USB device is not
playable on the unit.
An incompatible USB device is
connected to the unit.
Cause
The preset (memory) may have been
erased.
The FM antenna may be connected
improperly.
The radio station you selected may be
far from your area, or the radio wave
reception is weak in your area.
Multipath reflection or other radio
interferences may have occurred.
Cause
The remote control may be operated
outside its operation range.
The remote control sensor on the unit
may be exposed to direct sunlight or
lighting (inverted fluorescent lamps).
The battery may be worn out.
There are obstacles between the
sensor of the unit and the remote
control.
TROUBLESHOOTING
Solution
Set the system to off, and turn it on
again (☞ P. 4).
Disconnect the device while the system
is off. Then connect the device again
and turn on the system (☞ P. 4).
Connect an AC adapter if supplied with
the device.
Try another USB device.
Turn off the system and reconnect the
USB device to the unit. If the message
appears again, the USB device is not
compatible with the unit.
Solution
Preset radio stations again (☞ P. 14).
Make sure the FM antenna is connected
properly (☞ P. 14).
Try manual tuning to improve the
signal quality (☞ P. 14) or use a multi-
channel outdoor antenna.
Change the height, direction, or
placement of the antenna.
Solution
For information on the remote control
operation range, refer to "Using the
remote control" (☞ P. 3).
Change the lighting or orientation of the
unit.
Replace the battery with a new one
(☞ P. 3).
Remove the obstacles.
19
En

Publicité

Table des Matières
loading

Table des Matières