Fisher & Paykel DCS CPV2 Serie Guide D'utilisation page 23

PROBLEM
COOKTOP BURNERS
There is a power failure
– can I still use the
cooktop burners?
The flames have
suddenly gone out.
There is a slight
'extinction pop' or
flash after I've turned a
cooktop burner off.
TROUBLESHOOTING
POSSIBLE CAUSES
Power outage in your area.
A draft or a spill has
extinguished the flame.
WHAT TO DO
The cooktop burners can still
be used. To light them:
1 Holding a lighted
match to the flame
spreader, push in on the
control knob and turn
counterclockwise to LITE.
2 When the flame is
burning all the way
around the burner, you
may adjust the heat.
IMPORTANT!
If the flame is blown out
during a power failure, turn
the knob immediately to
OFF, as the burner will not
automatically relight and
gas may escape.
No action required. The
burner will detect this
and automatically relight.
However,
if there has been a large spill,
we recommend turning the
burners off and cleaning the
burners and sump area. See
'Care and cleaning' for
instrucions.
This is normal for LP gas and
requires no action.
EN
21