Fisher & Paykel RF175W Instructions D'installation Et Guide D'utilisation page 12

Installation instructions
EN
10
5. Installation (all models)
Your Fisher & Paykel Active Smart™ refrigerator is fitted with front and rear rollers, designed for
moving the product in the forwards and backwards direction.
Avoid moving the product in a sideways direction as this may damage the rollers or the floor
covering/ surface.
Your refrigerator will arrive with the front leveling feet wound up making moving this product
1
into its final location a simple task.
Roll the refrigerator into its final position making sure there is the correct air gap between the
2
product and the surrounding cabinetry. See minimum clearance in cabinetry dimensions table
(refer to page 7).
Using a hex headed screwdriver, or socket set,
3
turn the front adjustment screws (
to raise the product and counterclockwise to
lower the front of the refrigerator.
Ensure product is sitting backward with the front
4
approximately ⁄" (10 mm) higher than the back.
This will ensure a good door-closing action.
Align your refrigerator with cabinetry:
5
Align the sides of the refrigerator with
a
cabinetry by adjusting the right-hand side
adjustment screw.
Adjust the left-hand side adjustment screw
b
until it touches the floor and takes a small
amount of weight.
Once the refrigerator is in place and aligned
c
with the cupboards/alcove, push gently on the
front top and check if the product is rocking or
stable. If the product is rocking, refer to steps
7 – 10.
If the product is stable and no door leveling is
d
required, place toe grille onto the bottom of
the product (refer to figure 4):
Align the toe grille mounting clips with the
lower cabinet slots.
Push the toe grille firmly until it snaps into
place.
) clockwise
a
a
Fig.3 Adjustment screws
Fig.4 Toe grille installation
a