Pfannenberg DTS Notice D'utilisation page 8

Contents
1 Hints on the manual ....................................................... 8
2 Handling .......................................................................... 8
2.1 Transport .......................................................................... 8
2.2 Storage ............................................................................ 8
2.3 Unpacking ........................................................................ 8
3 Scope of delivery and options ....................................... 9
3.1 Scope of delivery ............................................................. 9
3.2 Optionen .......................................................................... 9
4 General Information ....................................................... 9
5 ID Plate and Technical Data .......................................... 9
6 Safety .............................................................................. 9
7 Function .......................................................................... 9
7.1 Principles of function ........................................................ 9
7.2 Condensate ...................................................................... 9
8 Installation ..................................................................... 10
8.1 General ........................................................................... 10
8.2 Installation of side-mounted, bolt-on cooling unit
DTS ................................................................................ 10
8.3 Installation of built-in cooling unit DTI ............................ 10
8.4 Power connection ........................................................... 11
9 Operationg Conditions ................................................. 11
10 Putting into operation and function ............................ 11
10.1 General remarks ............................................................. 11
11 Cleaning and Maintenance ........................................... 11
11.1 Cleaning .......................................................................... 11
11.2 Maintenace ..................................................................... 11
12 Stopping ........................................................................ 12
13 Warranty Conditions ..................................................... 12
Read this manual completely and carefully
before installing the unit.
This manual is an integral part of the scope
of delivery and must be kept until the unit is
disposed of.
8
1 Hints on the manual
This handbook contains instructions for the installation and operation
of
• Door and side-mounted, bolt-on Cooling Units, Series DTS,
• Door and side-mounted, built-in Cooling Units, Series DTI.
Hint
The technical specifications for each machine along with additional
information on assembly, connections and operation are contained
in a separate sheet.
In this manual, safety recommendations and other information are
structured as follows:
Hazard!
If the measures described in the following are not strictly
observed there is danger to life and health.
Hazard!
If the measures described in the following are not strictly
observed there is danger to life and health due to electri
cal shock.
CAUTION:
If the measures described in the following are not strictly
observed material damage may be caused.
Hint
A hint contains additional information on the action or instruction
described.
2 Handling
2.1 Transport
• Lift cooling unit only by the casing or with two jack rings (M8)
• Transport the cooling unit only in condition of usage.
• Prior to transport remove the cooling unit and pack it separately
if the complete switch cabinet is to be transported.
Failure to observe these instructions will render the warranty provi-
sions null and void.
2.2 Storage
• Never expose cooling units to temperatures exceeding +70 °C
during storage.
• Store cooling unit only in condition of usage.
Failure to observe these instructions will render the warranty provi-
sions null and void.
2.3 Unpacking
• Prior to and during unpacking make a visual inspection of the
cooling unit to see whether any damage has occurred during
transport. Especially pay attention to loose parts, dents, scrat
ches, visible loss of oil etc.
Any damage must be reported immediately to the forwarding
agent (follow the instructions in "Rules for Damage Claims").
Moreover, the latest edition of the "General Conditions for Sup
plies and Services" issued by the ZVEI ( Central Association
for the German Electrotechnical Industry") shall apply.
• Before disposing of packing material ensure that it does not
contain any loose components.
Danger!
Burr caused by production may be present on the metal
edges of the unit. Always wear protective gloves when
carrying out maintenance work and installation.
In case of a warranty claim exact details on the fault (pho-
tograph, if possible) and the indication of type and serial
number of the cooling unit are required.
085 408 164