Media Player - Schneider LED24-SCP090HDVD Manuel D'utilisation

Media Player

Before operating MEDIA menu, plug in USB device, then press SOURCE button to
set the input source to Media.
Press button to highlight your preferred submenu: Photo, Music, Movie and
e-Book, press OK button to confirm.
Basic operation for photo, music and movie:
1) RED: Delete highlighted files.
2) GREEN: Add/remove all the files to play list
3) OK:Add/remove highlighted file from play list.
4) CH+/-: Page up/down
5) Press ► button to start playing.
Remark: Depending on the capacity of the device, the reading can take more
than 1 minute before lauching the video.
The unit cannot read my USB device.
- Once you have plugged your device to the unit, you may need to switch on the USB
device before it can operate.
- This unit does not support a direct USB connection with a computer. You need to
use a USB device, a MP3 player or a PMP (Portable Multimedia Player with hard
disk).
- If you are using a USB external hard disk: you need to connect your device
simultaneously to an external power source and to the unit. If you are using a self-
powered PMP, make sure that the battery is sufficiently loaded.
- Check that the files system of your USB device is formatted into the FAT 32 format.
USB device formatted into NTFS are not compatible with this unit. Caution: if you
attempt to modify your file system, formatting your device will erase all data.
Please refer to your USB device's instruction manual first.
- Warning: Connect your USB device directly to the USB port of the device.
Using an extension cable is not recommended and may cause interference and
failure of data transfer.
*.MKV,*.MPG, *.DAT (MPEG1/MPEG2),*.TS
1080*
*.VOB (MPEG-2MP@ML)
1080*
*.AVI (MPEG-4),*.MP4
1080*
66
E-book
Txt(*.txt)
BMP