Media Player - Schneider LED32-SCPX200H Manuel D'utilisation

Media Player

Before operating
set the input source to
Press button to highlight your preferred submenu: Photo, Music, Movie and
e-Book, press OK button to confirm.
Basic operation for
1) RED: Delete highlighted files.
2) GREEN: Add/remove all the files to play list
3) OK: Add/remove highlighted file from play list.
4) CH+/- : Page up/down
5) Press ► button to start playing.
Remark: Depending on the capacity of the device, the reading can take more
than 1 minute before lauching the video.
The unit cannot read my USB device.
- Once you have plugged your device to the unit, you may need to switch on the USB
device before it can operate.
- This unit does not support a direct USB connection with a computer. You need to
use a USB device, a MP3 player or a PMP (Portable Multimedia Player with hard
disk).
- If you are using a USB external hard disk: you need to connect your device
simultaneously to an external power source and to the unit. If you are using a self-
powered PMP, make sure that the battery is sufficiently loaded.
- Check that the files system of your USB device is formatted into the FAT 32 format.
USB device formatted into NTFS are not compatible with this unit. Caution: if you
attempt to modify your file system, formatting your device will erase all data.
Please refer to your USB device's instruction manual first.
- Warning: Connect your USB device directly to the USB port of the device.
Using an extension cable is not recommended and may cause interference and
failure of data transfer.
*.M KV *.MPG, *.DAT (MPEG1/MPEG2) ,
1080*
*.VOB (MPEG-2MP@ML)
1080*
*.AVI (MPEG-4),*.MP4
1080*
MEDIA menu, plug in USB device, then press
Media .
photo, music and
,*.TS
movie :
63
SOURCE button to
E-book
Txt(*.txt)
BMP