Tuner Operations; Fm Tuning; Automatic Tuning; Manual Tuning - Yamaha PianoCraft MCR-840 Mode D'emploi

TUNER OPERATIONS

There are 2 tuning methods: automatic and manual. You can also use the automatic and manual preset tuning features to
store up to 30 stations.

Automatic tuning

Automatic tuning is effective when station signals are
strong and there is no interference.
1
Press TUNER to set the receiver to FM mode.
2
Press and hold TUNING
2 seconds to begin automatic tuning.
When the receiver is tuned into a station, the TUNED
indicator lights up and the frequency of the received
station is shown on the front panel display.
d d d
• Press to tune into a lower frequency.
d
• Press to tune into a higher frequency.

Manual tuning

If the signal received from the station you want to select is
weak, tune into it manually.
1
Press TUNER to set the receiver to FM mode.
d d
2
Press TUNING / d d
station manually.

FM TUNING

TUNER
d d
TUNING / d d
d d
/ d d for more than
to tune into the desired

Automatic preset tuning

Follow the procedure below to preset radio stations
automatically.
MEMORY
1
Press TUNER to set the receiver to FM mode.
2
Press and hold MEMORY for more than 2
seconds.
The PRESET indicator starts flashing on the front
panel display and automatic station preset starts.
When all frequencies are searched, preset stops
automatically.
• The search starts at the lowest frequency and goes
toward the highest frequency.
• The receiver automatically applies a preset number
to each detected station.
• To cancel the search, press MEMORY.
Notes
• You can preset up to 30 FM stations.
• Any stored station data existing under a preset station number is
cleared when you store a new station under the same preset
station number.
TUNER
PRESET u / d
29
En