Problem-Solving And Troubleshooting - Corghi Erco X5000 CT LT PT2 FAST Manuel D'utilisation

Mineral oil: first aid procedures
- Swallowing: go to Casualty with the characteristics of the type of oil swallowed.
- Inhaling: in case of exposure to strong concentration of vapours or mists, take the af-
fected person out into the open air and then to Casualty.
- Eyes: rinse with plenty of water and go to Casualty as soon as possible.
- Skin: wash with soap and water.
PROBLEM-SOLVING AND
TROUBLESHOOTING
Initial buttons test
1 - When the lift is switched on the led indicators ALARM1, ALARM2, OK on the control
panel turn on for 2 seconds (indicator operation check).
2 - At the beginning and at the end of the two second test, the processor checks that all
the buttons are in rest position (not activated).
3 - If one or more buttons are pressed, at the end of the start-up test, the system illumi-
nates the alert lights and switches over to ALARM 1 status.
4 - It is possible to find out which button has been pressed (or was jammed in down
position) during the initial test by pressing them all in sequence. When buttons which
had not been pressed (or were not jammed down) are pressed during the initial test,
the alarm light will go out, while when buttons which had been pressed (or were jammed
down) are pressed, the alarm light will remain on.
Using the keypad in normal operation
The control panel has a maximum of 10 buttons.
6 of them are of operating-type, they control the up, down and safe parking functions and
quick positioning for the main lift and, where present, for the free-wheel lift.
Simultaneously pressing several operating buttons is not permitted and immediately
halts the function in progress.
UK
To resume normal operation of the lift, all the buttons must be released.
The 4 remaining buttons are functional and can be pressed during the operations.
In particular, button F has no direct functions but it allows the access to the second func-
tion present in some buttons.
The correct sequence to access the second function is the following:
a - Press and hold down button F.
b - Press and hold down the button with the desired second function.
The second function is started.
c - Release both buttons to stop the current second function.
Operator's manual ERCO X5000 CT LT PT2 FAST 79