Resetting The Unit - Sharp EL-1611E Mode D'emploi

PRINTING SECTION
Printing speed: Approx. 1.4 lines/sec. (Printing speed
changes slightly depending upon the
printed digits per line.)
Printing paper: 57 mm (2-1/4") – 58 mm (2-9/32") wide
80 mm (3-5/32") in diameter (max.)
Operating temperature: 0°C – 40 °C (32°F – 104°F)
6V ... — (DC):
Power consumption:
96 (W) × 191 (D) × 40 (H) mm
Dimensions:
3-25/32" (W) × 7-17/32" (D) × 1-9/16" (H)
Weight: Approx. 315 g (0.69 lb.) (with batteries)
Ink roller × 1 (installed), Paper roll × 1,
Accessories:
Dry battery (R6) × 4 and Operation
manual
98305_EL-1611E(LC7)_Eng.pm65 11
Strong impacts, exposure to electrical fields, or other unusual
conditions may render the unit inoperative, and pressing the keys
will have no effect. If this occurs, you will have to press the RESET
switch on the bottom of the unit. The RESET switch should be
pressed only when:
• an abnormal event occurs and all keys are disabled.
W
• you install or replace the batteries.
Notes:
• Pressing the RESET switch will clear the stored exchange rate
and other data stored in the memory.
• Use only a ballpoint pen to press the RESET switch. Do not use
anything breakable or anything with a sharp tip, such as a needle.
• After pressing the RESET switch, press
"0." is indicated.

RESETTING THE UNIT

ON
to make sure that
C·CE
0.3.6, 1:24 PM
1 2 3 4 5 6 7 8 9 0 . ,
1 2 3 4 5 6 7 8 9 0 . ,
1 2 3 4 5 6 7 8 9 0 . ,
1 2 3 4 5 6 7 8 9 0 . ,
1 2 3 4 5 6 7 8 9 0 . ,
1 2 3 4 5 6 7 8 9 0 . ,
11