Quick Setup Tab; Network Settings Tab - essentiel b Solo Notice D'utilisation

Quick Setup tab

Configure your WiFi powerline adapter by following the steps in the Quick Setup menu.
Point d'accès (Access point): Adds wireless access to your wired network.
•
Point d'accès (Access point) is selected and then click Suivant (Next).
−
Enter a WiFi network name if you want to change the network name. The default network name is
−
CPL_WIFI_1200_2.4G_XXXXXX or CPL_WIFI_1200_5G_XXXX depending on the type of network
you want to use.
Select the channel.
−
Select the security level, then enter the security key (located on the WiFi powerline adapter).
−
Click Suivant (Next).
−
Click Sauvegarder (Save) to save your settings.
−
46

Network Settings Tab

PARAMETRES WI-FI (WIFI SETTINGS)
This page allows you to set up the 2.4 Ghz or 5 Ghz WiFi network.
Wireless: Enable or disable the WiFi setting.
•
Network mode: Select the right mode based on your wireless clients.
•
11b: This network mode offers a wireless speed of up to 11 Mbps. It is only compatible with 11b
−
wireless clients.
11g: This network mode offers a wireless speed of up to 54 Mbps. It is only compatible with 11g
−
wireless clients.
11b/g: This network mode offers a wireless speed of up to 54 Mbps. It is only compatible with
−
11b/g wireless clients.
11b/g/n: This network mode offers a wireless speed of up to 300 Mbps. It is only compatible with
−
11b/g/n wireless clients.
SSID: Displays the name of the WiFi network (by default CPL Wi-Fi 1200_XXXX).
•
Broadcast (SSID): Select Activé (Enabled) to allow the powerline adapter to search for wireless devices.
•
The default value is Activé (Enabled). If you disable this option, wireless devices must recognise the
adapter's SSID (network name) to establish a wireless link.
Channel: This option allows you to select a channel. The default value is Autosélection (Auto-select).
•
Channel bandwidth: Select the appropriate channel bandwidth to improve wireless performance. Select
•
20/40 when the network has wireless clients in 11b/g and 11n mode. Select 20 when the network has
only wireless clients in non-11n mode. Select 40/80 to increase its speed when the wireless network
is in AC mode.
47