Getting Started - Sony Trinitron Multiscan 300sf Mode D'emploi

Getting Started

This monitor will sync with any IBM or compatible system
equipped with VGA or greater graphics capability.
Although this monitor will sync to other platforms running
at horizontal frequencies between 30 and 86 kHz, including
Macintosh and Power Macintosh system, a cable adapter is
required. Please consult your dealer for advice on which
adapter is suitable for your needs.
Step 1: With the computer switched off, attach the video
signal cable to the monitor (HD15/5 BNC's) and
attach the other end to the video card.
IBM or Compatible
Computer
to video output
HD15 - HD15 adapter
(supplied) may be required∗
Apple Computer
to video output
Macintosh adapter
(not supplied)
IBM or Compatible
to video output
Computer
HD15 - HD15 adapter
(supplied) may be required∗
Apple Computer
to video output
Macintosh adapter
(not supplied)
∗ For the customers using IBM PC or IBM
compatible system which is not compatible with
DDC2AB and DDC2B+
This monitor uses a No.9 pin in the video signal connector
for DDC2AB and DDC2B+ compatibility.
Some PC systems which are not compatible with either
DDC2AB or DDC2B+ may not accept the No.9 pin. If you
are not sure whether your PC system accepts the No.9 pin
or not, use the HD15 (Female) - HD15 (Male without the
No.9 pin) adapter (supplied). Make sure that the male side
(without the No.9 pin) is connected to the computer.
4
Step 2: With the monitor switched off, attach the power
to a wall outlet
Step 3: Turn on the monitor and computer.
Step 4: Switch the input connector according to the
Step 5: If necessary, adjust the user controls according to
to HD15
For the customers using the Windows
Even if you select SONY for the maker on the device select
screen, the model name (CPD-300SFT5) may not appear.
In this case, select the DDC standard monitor.
Video signal cable
(supplied)
The installation of your monitor is complete. Enjoy your
monitor.
Notice
To comply with the limits of FCC Class B and IC Class B for
digital device, please attach the supplied video signal cable
for HD15 input or SMF-400 (sold separately) for BNC input.
Furthermore, each cable has ferrite cores on it.
to
VIDEO IN R/G/B
SYNC IN HD/VD
Video signal cable
SMF-400
(sold separately)
cord to the monitor and the other end to the power
outlet.
Power cord (supplied)
adjustment procedure on page 9.
your personal preference.
®4) 95