Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
The air intake must be positioned so that it cannot be obstructed.
•
Be communicating with the installation room of the appliance and be protected by grating.
•
Minimum surface must not be lower than 113 cm
•
Should the inflow of air be obtained by openings communicating with outside of nearby rooms, it is
necessary to avoid air intakes in connection with garages, kitchens, bathrooms, thermal units (see
Picture 14).
(1) Insulating material
(3) Insulating coating with external
aluminum sheet
(4) Door for cleaning
(5) External air intake
Picture 14
9.
CONNECTION AND MAINTENANCE OF VENTILATION
The control unit and the plant must be installed and connected by authorized personnel according to the
standards in force. (see chapter.1)
ATTENTION: the feeding cable must not be in contact with hot parts.
Our inserts are equipped with tangential fans suitable to improve the distribution of heat through the ventilation
exclusively of the installation room (see chapter.6).
The lighting and the adjustment is carried out through the proper standard supplied control unit that has to be installed
far from any direct heat source. The kit is equipped with a thermostat (TM) that lets the fans start when the appliance
is properly heated, and stops them when it is partially cold.
If the control is switched on (pos.
temperature is achieved.
MANDATORY: cable
out of seeing!
Picture 15
22
(2) Seal
halfway speed – pos.
I
INSERTO 60 – 70 – 70 To – 70 Pr – 70 H49
2
.
(6) Heat drain grating
(7) Fire-retardant counter-hood
(8) Maximum inclination 45°
(9) Shield wooden parts with
insulating material
THE REGIONAL REGULATIONS
(10) Min. distance between Coating and
INSERT
see MARKING INFORMATION
maximum speed), the ventilators work when a pre-set
II
L
N E E M M
Ph
Marrone
Blu
Giallo / Verde
230 V~ – 50Hz
Picture 16
ACCORDING TO
Marrone
Blu
M
M
TM
Giallo / Verde
6090710 – EN
Publicité
Table des Matières
