Trouble Shooting; Regulations; Technical Features; Eu Declaration Of Conformity - stayer OLMO G1-250B Instructions D'emploi

8. Trouble shooting

Malfunction
The saw chain does not move Saw chain brake
Ignition system
The engine does not start or
only with difficulty
Fuel delivery
Compression system
Mechanical malfunction
Difficulties at hot starts Carburetor
The engine starts but Fuel delivery
stalls immediately
Insufficient power Several systems may be
involved simultaneously
No saw chain lubrication Oil pump/tank

9. Regulations

9.1. Technical features

= Power in watts
W
= Horsepower
HP
c.c
= Cylinder capacity
= Cutting length
= Mass
= Carburetor
= Fuel tank capacity
= Chainsaw oil tank capacity
= Ignition system
SYSTEM
CHAIN
= Chain brake
BRAKE
= Noise
L
= Acoustic power level
WA
L
= Sound pressure level
pA
= Vibration
System Remark
The engine works
Ignition spark
There is no ignition spark
The fuel tank is full
Inside
Outside
The starter does not
actuate
The fuel tank is full
Ignition spark
The fuel tank is full
The engine is idling
There is no oil on the
saw chain
ENGLISH
22
The saw chain brake is activated
Malfunction of the fuel delivery system, compression system or mechanical
malfunction.
The switch is on "STOP", failure or short circuit in the cabling, spark plug
cap or faulty spark plug.
Throttle in wrong position, faulty carburetor, suction head dirty,
fuel pipe bent or interrupted.
Sump seal faulty, packaging of the radial axles faulty,
cylinder or piston rings faulty.
The spark plug does not close hermetically.
The spring of the starter is broken, broken pieces inside the engine.
Incorrect adjustment of the carburetor.
Incorrect idling adjustment, suction head or carburetor dirty. Ventilation of the
tank faulty, fuel pipe interrupted, faulty cable, faulty STOP switch.
Air filter dirty, incorrect adjustment of the carburetor, muffler clogged,
exhaust channel of the cylinder clogged.
Oil tank empty .
Oil guide slot dirty.

9.2. EU declaration of conformity

The undersigned: STAYER IBERICA, S.A.
With address at:
Calle Sierra de Cazorla, 7
Área Empresarial Andalucía - Sector 1
28320 PINTO (MADRID)
Tel.: +34 902 91 86 81 / Fax: +34 91 691 91 72
CERTIFIES
That the machine:
Type:
MOTOSIERRA
Models:
OLMO G1-250B
OLMO G2-400B
OLMO G3-450 B
OLMO 22-400 B
We declare under our sole responsibility that this product is
in conformity with the following standards or standardized
documents:
EN 14982, EN ISO 11681-2, EN 61000-4-2, EN 61000-4-
3, CISPR 12, according to EU Regulations 2006/42/EC,
2014/30/EU, 2000/14/CE.
Ramiro de la Fuente
Director General
January, 2018
22
Cause