Sony HANDYCAM HDR-CX760V Mode D'emploi page 24

To adjust the angle of the LCD panel
First open the LCD panel 90 degrees to the
camcorder (), and then adjust the angle
().
To turn off the beep sound
 [Setup]  [
Select
Notes
The recording date, time and condition, and coordinates (HDR-CX760V/PJ710V/PJ760V) are recorded

automatically on the recording media. They are not displayed during recording. However, you can
check them as [Data Code] during playback. To display them, select
Settings]  [Data Code]  [Date/Time].
Once the clock is set, the clock time is automatically adjusted with [Auto Clock ADJ ] and [Auto Area

ADJ] set to [On]. The clock may not be adjusted to the correct time automatically, depending on the
country/region selected for your camcorder. In this case, set [Auto Clock ADJ ] and [Auto Area ADJ] to
[Off] (HDR-CX760V/PJ710V/PJ760V).

[Power On By LCD] (HDR-PJ710/PJ710V) (p. 72)

To set the date and time again: [Date & Time Setting] (p. 73)

To calibrate the touch panel: [Calibration] (p. 84)

US

 90 degrees (max.)
 180 degrees (max.)
General Settings]  [
 90 degrees to the camcorder
]  [Off].
Beep
 [Setup]  [
Playback