Publicité
Les langues disponibles
Les langues disponibles
(MM-2400) CONTROLS:
ECHO SECTION:
32
An echo effect may be applied to the PGM, or MIC 1 & MIC 2
signals by switching the ECHO ASSIGN switch from MIC 1-2 on the
LEFT, to OFF in the MIDDLE, to MASTER on the RIGHT & vice
versa. When using ECHO, you may adjust the effect of the ECHO by
using the rotary REPEAT, DELAY, and ECHO VOLUME controls.
To turn the ECHO ASSIGN OFF or lower the ECHO VOLUME.
SOUND EFFECTS SECTION:
33
Six different sound effects (APPLAUSE, SCREAM, COPTER,
SCRATCH, H2O & GLASS) may be added to your mix by pressing
the SOUND EFFECTS CONTROL BUTTONS. The volume of the
effects can be adjusted using the rotary EFX VOLUME located
above the APPLAUSE effect button. The pitch of the effects can be
increased or decreased using the rotary SPEED CONTROL located
above the SCRATCH effect button.
MM-1800/2400
FADER REPLACEMENT:
1. UNSCREW THE FADER (B) SCREWS. DO NOT TOUCH INSIDE
SCREWS (C) CAREFULLY REMOVE OLD CROSS FADER AND UNPLUG
CABLE (D)
2. PLUG IN THE NEW CROSS
FADER INTO CABLE (D) AND
PLACE BACK INTO MIXER.
3. SCREW THE CROSS FADER TO
MIXER WITH THE FADER PLATE
SCREWS (B)
4. REPLACE THE FACE OF THE
MIXER AND SCREW THE FOUR
SCREWS BACK IN AND REPLACE THE FADER KNOBS.
SPECIFICATIONS:
INPUTS:
Phono:..........................................................................3 mV, 47 KOhm
Line:.........................................................................150 mV, 27 KOhm
MIC 1, 2, & 3:.............................................1.5 mV, 2 K Ohm Balanced
Bass:..........................................................................................± 12dB
High:...........................................................................................± 12dB
OUTPUTS:
Amp/Booth:.............................................................0 dB 1 V, 400 Ohm
Max:........................................................................20 V Peak-to-Peak
Rec.............................................................................150 mV, 5 KOhm
Zone........................................................................0 dB 1 V 400 Ohm
Balanced..................................................................6 dB 2 V 400 Ohm
GENERAL:
Frequency Response:.....................................20 Hz - 20 KHz +/- 2 dB
Distortion:....................................................................................0.02%
S/N Ratio:.................................................................Better Than 80 dB
Talkover Attenuation:..................................................................-16 dB
Headphone Impedance:...........................................................16 Ohm
Power Source:............................................115/230 V, 60/50 Hz, 20 W
Unit Dimensions:.................................................W 19" x H 4" x D 9.1"
..................................................................(482.6 x 100.6 x 231.2 mm)
Weight:..................................................................... 10.34 lbs (4.7 kg)
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTIFICATION
FOR IMPROVEMENT
7
Publicité
