AVG BSC42DB Manuel D'utilisation page 23

NOTES
If too many bottles are put in at once or the door has not been closed tightly, the unit will
display the "HI" signal on the display panel. This is normal. Please wait 5 minutes after closing
the door and "HI" will disappear.
It is normal that the cabinet shows "HI" or "LO" from time to time. If it occurs frequently or lasts
for a long time, you can restart the unit by unplugging it, then re-plugging after 5 minutes. If the
problem occurs again after restarting, please contact customer service.
Before reconnecting the power, wait 3 to 5 minutes. Otherwise you could damage your
appliance. If you attempt to start the appliance before the end of this time delay, the appliance
will not turn on.
If you turn on the appliance for the first time or after a restart, or after it has been out of
operation for a long time, there may be a temperature difference between the temperature
inside the appliance and that on the LED display. This is a normal event caused by the duration of
the activation period. Leave the appliance turned on for several hours and the temperatures will
stabilize during operation.
SHELVES
To prevent damaging the doors or gasket seals, open the doors wide when removing the shelves.
When removing any of these shelves out of the rail compartment, you must lift (from the rear)
and pull it towards you. To re-install, ensure the shelf is resting securely on the support brackets
and push shelf inward until it locks into place.
IMPORTANT: Do not cover the gap of glass shelves with aluminum foil or any other TYPE OF
material that will prevent adequate air circulation within the cabinet.
23