User Notice - T'nB KIDSCAM Mode D'emploi

Specifications
Optical f/2.6 mm Hemispherical Lens 4 elements
Wide angle 120°
Video Resolution 720P (1280*720p) 30fps ; VGA (640*480p) 30fps
Photo Resolution 5,3,1 MP
Format JPEG
White Balance Auto
Batterie 500 mAh lithium-ion
Charge Via câble micro USB/ USB
Audio Built-in microphone
Memory MicroSD card up till 32GB class 10 or higher version (not
included)
Recording Time Up till 90 min
Included cable Micro USB/ USB
Operating System Windows XP/Vista/ 7/8 / Mac10.8
Wight 56g
Screen Size 1,77''
Output Micro USB
Languages English, French, Spanish, Portuguese
Note : The information and settings explained in this manual have been there
since the debut of the manual and are susceptible to changes without any prior
intimation.
KIDSCAMB.indd 24-25

User Notice :

Connexion à un ordinateur
The device delivers exceptional images and
videos. Therefore, only the micro SD cards
of minimum class 10 are accepted by the
device
Battery care and storage
The camera contains delicate parts,
especially the battery. It is not advisable to
drop, dismantle, open, crush, bend, deform,
pierce, expose to micro waves, burn or
repaint the camera, or to insert things in the
battery opening. Do not use the camera or
the battery if they are damaged, for example
if they are cracked, punctured or water
damaged. If you dismantle or puncture the
battery, it may explode or catch fire. Do not
store your camera and battery in excessive
heat or cold. Very high or very low tempera-
ture can reduce the battery life or prevent
proper functioning. Avoid sudden changes
in temperature or humidity as condensation
may occur inside or outside the camera.
Battery disposal: The lithium-ion batteries
contain recyclable materials and are conside-
red recyclable. Find out about the local laws
and the recycling centres in your locality.
Before throwing the lithium-ion batteries,
cover the terminal parts with sticky tape or
with a packaging foil to isolate and prevent
EN
the terminals from coming into contact with
other metallic objects so that they do not
catch fire while transporting.
Prevention of damage due to the water in
your camera
The rubber seal that covers the inside of
the housing forms a waterproof barrier that
protects your sport camera in wet conditions
and under the water. Make sure that the
rubber seal remains clean. A single hair or
a grain of sand can cause a leak. After each
use in the salt water, you must rinse the
outside of the housing with some fresh water
and dry it. Otherwise, the pivot may rust and
the salt accumulates in the seal, which can
cause some failures. To clean the seal, rinse
it in the fresh water and shake it dry (wiping
with a cloth may leave fluff and compromise
the seal). Reinstall the seal into the slot of
the back door of the housing.
CAUTION: If you do not follow these precau-
tions whenever you use your sport camera,
the leaks can damage or destroy your came-
ra. The warranty does not cover the damage
caused by user error.
28/07/2017 12:42