Fault Reset; Firmware Upgrade - Sena SRL2 Mode D'emploi

24 FAULT RESET

When the SRL2 is not working properly or is in faulty status for any
reason, you may reset by pushing the pin-hole reset button located
next to the DC Power Charging & Firmware Upgrade Port. Insert a
paper clip into the reset pin-hole and press the reset button for a
second with light pressure. The SRL2 will be switched off, and you
have to turn on the system back on and try again. However, this will not
restore the headset to factory default settings.
1
The SRL2 supports firmware upgrade function. Please visit Sena
Bluetooth web site at www.sena.com to check the latest software
downloads.
2

25 FIRMWARE UPGRADE

SRL2
51