Sena SRL2 Mode D'emploi page 259

Note:
You have to use a motorcycle specific GPS which transmits turn-by-turn
voice instruction to the headset by Bluetooth. Most automotive GPS systems
don't have this feature.
4.5 Pairing with the Sena SR10, Bluetooth Two-way
Radio Adapter
The Sena SR10 is a Bluetooth two-way radio adapter for group
communication, and uses HFP as do most motorcycle specific GPS
navigation systems. If you pair the SRL2 with an SR10 by second
mobile phone pairing, the SRL2 is able to have two HFP devices at the
same time: a mobile phone and the Sena SR10.
1. Turn on the headset and press the Center Button for 12 seconds
until you hear high-toned double beeps. You will hear a voice
prompt saying "Configuration menu".
2. Within 2 seconds, double tap the (+) Button, then the LED turns to
blue flashing and the beeps turn to high-toned double beeps. You
will hear a voice prompt saying "Second mobile phone pairing".
3. Turn on the SR10 and follow the SR10's "Bluetooth Headset
Pairing" procedure to complete the process. Please refer to the
SR10 User's Guide for details.
4. When the pairing is completed, you will hear a voice prompt
saying "Your headset is paired".
5. If the pairing process is not completed within three minutes, the
SRL2 will return to stand-by mode.
The incoming audio from the two-way radio via SR10 is heard in the
background while having an intercom conversation or a mobile phone
call. You can listen to music, answer a mobile call, have an intercom
conversation and use a two-way radio via the SR10 for group
communication as shown in the figure below. A GPS navigation or a
radar detector which has a headphone jack or audio line-out could be
connected to the SR10 by a wire. The GPS voice instruction or the
radar detector alarm is also heard in the background via the SR10
while having an intercom conversation or a phone call. Please refer to
the SR10 User's Guide for details.
SRL2
21