Overheating Safety Device; Maintenance And Storage - Argo Chic Silver Instructions D'utilisation

3. Press TIME/ON to set the switch-on time (00-24)
4. Press TIME/OFF to set the switch-off time (00-24)
5. Press the + or – buttons to set the desired temperature
6. Press OK to confirm the settings
To set any other subsequent operating times, (max 6) repeat the procedure from point 2 to point 6.
Repeat the procedure from point 1 to set the other days of the week.
After completing the weekly timer setting, press the buttons DAY EDIT TIME/ON and TIME/OFF to check the settings for each
day.
All settings are deleted when the fan heater is switched off using this switch
"OPEN WINDOW" FUNCTION SETTING
When the appliance is operating, press the
function; the LED appears on the display, as shown in the figure
to set the temperature. When this function is active, if the room temperature drops by 5-10°C in less than 10 minutes, the fan
heater stops operating and switches to stand-by mode. Press
If both the weekly timer and open window functions are set and, according to the weekly programme, the appliance is off, the
window open function will also be inactive. Conversely, when the appliance is operating in line with the weekly programme,
the window open function can control the ON/OFF operation of the appliance.
In the event of overheating, the protection system of the appliance will automatically disable the heating elements and the
motor, thus causing the fan heater to stop working.
In this case:
• turn the fan heater off;
• remove the causes of the overheating (e.g. obstacles in front of the air input/output grilles, dust build-up inside the
appliance, etc.);
• leave the appliance to cool down for 15-20 minutes;
• turn the fan heater on again and check that it works properly.
If the malfunction persists, contact an Authorised Service Centre.
CAUTION: ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR PERFORMING ANY MAINTENANCE.
IMPORTANT: DO NOT SUBMERGE THE FAN HEATER IN WATER.
Cleaning the outside surface of the appliance
Switch off the appliance and unplug it before cleaning or moving the appliance.
Use a soft cloth to remove any dust from the product.
If this is not enough, use a soft cloth dampened with water and neutral detergent at a temperature below 50 °C. Leave the
appliance to dry thoroughly before using it again.
Do not use corrosive detergents or solvents such as petrol. Do not wash the appliance with water.
appliance, do not use oils, chemical substances or other items that may damage the surface.
Use a vacuum cleaner to remove dust from the air inlet/outlet grilles.
STORAGE
If the appliance is not used for prolonged periods, it must be stored together with this manual in its original packaging, in a
cool and dry place.
V 06/19

OVERHEATING SAFETY DEVICE

MAINTENANCE AND STORAGE

button on the remote control to activate the open window
:
to restart the appliance.
Press the + or – buttons
When cleaning the
20