Argo Chic Silver Instructions D'utilisation page 19

Connect the power cable to a suitable electric socket (220-240V~50Hz), as indicated in the data plate.
SWITCHING THE FAN HEATER ON
Press the button on the appliance to switch the fan heater to stand-by mode. Press the
to switch the appliance ON.
AUTOMATIC FLAP SWIVEL
Press the button on the control panel or
ACTIVATION OF SUMMER VENTILATION (FAN) AND HEATING (ECO – COMFORT) MODES
Press the button on the control panel or
In stand-by mode the LED display is the following:
In Summer ventilation (FAN) mode the LED display is the following
In ECO heating mode (1000 W) the LED display is the following:
In COMFORT heating mode (2000 W) the LED display is the following:
To return to stand-by mode press the buttons
The default set temperature is 23°C.
The fan heater switches off about 30 seconds after the stand-by mode has been activated.
TEMPERATURE REGULATION
The temperature can only be set via the remote control. Press the + or – buttons to regulate the desired temperature (from
10°C to 49°C). If you set the temperature to 25°C the "°C" LED comes on as shown in the figure:
Press to cancel the temperature setting.
ECO SMART FUNCTION
The fan heater operates at maximum power (COMFORT mode) when the set temperature is at least 4°C higher than the
room temperature; if the set temperature is 0-2°C higher than the room temperature, the fan heater operates at medium power
(ECO mode), if the room temperature is higher than the set temperature the fan heater switches off and starts operating again
when the room temperature drops 2°C below the set temperature.
ON/OFF DAILY TIMER SETTING
In stand-by mode, press the
pressing on the same button to move on in intervals of 1 h: the default set temperature when it switches on is 23°C.
When the appliance is operating, to set the switch-off timer press the
hours, by pressing on the same button to move on in intervals of 1 h.
TIME SETTING (Only from the remote control)
Press the SET button to show the time on the display; press the + or – buttons to set the current hour (00-24); press the SET
button again to set the minutes (00-59); press the SET button again to set the day of the week – if you press + or – the display
will show the following abbreviations: d1, d2, d3,... which correspond respectively to Monday, Tuesday, Wednesday etc.;
once you have selected the current day press OK to confirm.
SETTING THE WEEKLY TIMER (only via the remote control)
After having set the time and day of the week, press P to enter the weekly timer setting,
1. Press DAY to set the switch-on day (d1, d2, d3,...),
2. Press EDIT to set the operating periods for the fan heater (P1, P2,... P6)
V 06/19
HOW TO USE THE FAN HEATER
on the remote control to select the operating mode.
on the remote control to select the operating mode.
or again respectively on the appliance and on the remote control.
button to set the switch-on timer. The switch-on timer can be set from 1 to 12 hours, by
button; the switch-off button can be set from 1 to 12
on the remote control
19