Argo Chic Silver Instructions D'utilisation page 17

The fan heater must be installed on the wall before use. Do not try to use it without installation. The installation sequence is
listed below:
1. Select a space for installing the appliance (figure 1).
2. Drill two holes on the wall that are suitably sized for inserting the Ø 8 mm Fischer screw plugs. (figure 2) – D=575 mm
Figure 1
3. Insert the Fischer screw plugs into the holes and tighten the screws provided.
NOTE: Tighten the screws securely. Do not insert the screws into the Fischer plugs entirely - leave around 10 mm free.
4. Mount the appliance on the wall (figure 3).
Ensure that the holes on the rear of the appliance are directed towards the two screws, push the fan heater backwards
onto the wall then downwards until it lies in a stable position.
CONTROL PANEL AND LED DISPLAY ON THE APPLIANCE
ROOM
TEMPERATURE
DISPLAY
V 06/19
HOW TO INSTALL THE FAN HEATER
ECO Mode LED
energy saving (1000
W)
WEEKLY
TIMER LED
Figure 2
COMFORT Mode LED
Maximum heat (2000 W)
OPEN WINDOWS
Mode LED
Fischer
Figure 3
ON/OFF BUTTON
TIMER
BUTTON
F BUTTON
Function selection
TIMER LED
TEMPERATURE
°C LED
17