Setting Up Rcube-To-Rcube Transmission - Arcam rCube Mode D'emploi

Setting up rCube-to-rCube transmission

With two rCubes, one rCube can receive wireless
transmissions from the other.
Any music played on the transmitting rCube, from an iPod or
an external source, will be sent wirelessly to the second rCube.
Before transmitting for the first time, you must associate the
transmitting rCube with the receiving rCube.
After an association is established it is remembered, even
if the units are powered off. Note: Association must be
performed twice if you want each cube to be able to transmit
to the other - you will need to repeat the steps below with the
cubes switched around. Once this is done, you'll be able to set
either cube to receive whatever the other is playing.
1
Power on all rCubes
Connect power, turn on at the rear panel and
power on using the top panel standby buttons, so
that the power LED glows blue.
2
Set the transmitter rCube to search for
receiver rCubes
Press and release the source select button to select
the source (iPod or AUX) that you want to
transmit. Press and hold the wireless button
until the wireless LED flashes red. For the next
30 seconds this transmitter rCube will associate
with any rCube searching for an association
(see step 3).
3
Set the receiver rCube(s) to search for a
transmitter
Press the wireless button to select the wireless input.
Release the button briefly, then press and hold.
The wireless LED will flash red as it searches for a
transmission. When the wireless LED on the rCube
glows continuous green, the association has been made.
Wireless Range
An rCube can normally receive from a
transmitter situated in the same house.
Range may be reduced depending on
building materials and interference from
other wireless sources such as cordless
telephones and WiFi routers. If you
experience problems with the wireless
signal, try moving either the receiving
rCube or the transmitter to a different
location. Wireless operation cannot be
guaranteed in hostile RF environments.
The transmitting rCube will continue
to search for receiver rCubes for 30
seconds. Do not interrupt this process –
wait until the wireless LED glows green
before powering off the transmitter
rCube.
E-22
O I
Aux
? >
VOLU
?
SOU
iP
PROG