Setting Up The Rwave - Arcam rCube Mode D'emploi

Setting up the rWave Optional USB transmitter
The Arcam rWave wireless USB transmitter lets you play
music anywhere in the home from files on your PC.
You can purchase the optional Arcam rWave USB wireless
transmitter for your rCube to broadcast your computer music
anywhere around the house. To purchase the rWave please visit
your local ARCAM dealer or visit www.arcam.co.uk. Before
using the rWave for the first time, you must associate it with
a particular rCube receiver.
You only need to perform this setup once. After an
association is established it is remembered, even if the
units are powered off.
1
Install the rWave USB transmitter
into your PC or laptop
Plug the USB disk drive-style rWave transmitter into
a free USB port in your computer. The computer will
recognize the device as a sound device and set it as
your default output device.
2
Set the rWave to search for a rCube
Press the 'associate' button on the rWave USB
transmitter. The rWave LED will flash rapidly
indicating it is searching for an association. For
the next 30 seconds the rWave will associate with
any rCube also searching for an association
(see step 4).
3
Turn on the rCube
Plug in and switch the rCube to on by pressing the rear
panel rocker switch to the on position and pressing the
top panel standby button, so hat the power LED is blue.
4
Set the rCube to search for a transmitter
Press the wireless button to select the wireless input.
Release the button briefly, then press and hold.
The wireless LED will flash red as it searches for a
transmission. When the wireless LED on the rCube
glows continuous green, the association has been made.
The rWave remains in association mode for 30 seconds in
case any more cubes are being set up. Do not remove the
rWave from the PC during this time. When association
is finished, the LED on the rWave will flash briefly every
five seconds. You will now be able to hear the wireless
source.
E-18
1
3
O I
? >
VOLU
?
SOU
Aux iP
PROG