Setting Up The Rwand - Arcam rCube Mode D'emploi

Setting up the rWand Optional iPod transmitter
The Arcam rWand wireless Apple-compatible transmitter means
you can play music anywhere in the home from your Apple iPod,
iPhone or iPad.
You can purchase an Arcam rWand wireless transmitter for your
rCube to broadcast your iPod's music wirelessly around the house.
To purchase the rWand please visit your local ARCAM dealer or visit
www.arcam.co.uk. Before using the rWand for the first time, you must
associate it with a particular rCube receiver.
You only need to perform this setup once. After an association
is established it is remembered, even if the units are powered
off.
1
Insert the rWand iPod transmitter into your iPod, iPhone
or iPad.
Plug the rWand into the docking connector at the
bottom of your Apple player.
2
Set the rWand to search for a rCube
Press the 'associate' button on the rWand
transmitter within 3 seconds of inserting it.
Hold the button until the transmitter LED
flashes rapidly (5 times per second) indicating it
is searching for an association. For the next 30
seconds the rWand will associate with any rCube
also searching for an association (see step 4).
3
Turn on the rCube
Plug in and switch the rCube to on by pressing the
rear panel rocker switch to the on position and
pressing the top panel standby button, so that the
power LED is blue.
4
Set the rCube to search for a transmitter
Press the wireless button to select the wireless
input. Release the button briefly, then press and
MEN U
, .
;4
hold. The wireless LED will flash red as it searches for
a transmission. When the wireless LED on the rCube
glows continuous green, the association has been made.
The rWand remains in association mode for 30 seconds
in case any more cubes are being set up. Do not remove
the rWand from the iPod during this time. When
association is finished, the LED on the rWand will flash
briefly every five seconds. You will now be able to hear
music played from the iPod.
E-20
, .
;4
23425
3
O I
Aux
? >
VOLU
?
SOU
iP
PROG