Lincar Lola 540 VT Instructions page 59

PROGRAM DAY. The programs inserted in this section will be repeated every day of the
week in the same way (max 2 ON/OFF cycles)
PROGRAM WEEK. With the programs inserted in this section you can effect different
ON/OFF during the days of the week (max 4 ON/OFF cycles
PROGRAM WEEK-END. The programs inserted in this section will be repeated exclusively
on Saturday and Sunday (max 2 ON/OFF cycles).
MENU 04 (language)
Within this Menu you can change the language utilized by the control panel. There are 4
possibilities: ItalianEnglish German French
MENU 05 ( stand-by)
The appliance is preset to work in 2 (two) different modalities
st
1 Modality, -STAND-BY OFF- as prearranged by the factory.
Once the appliance has reached one of the selected temperature, it start the modulation and it
start to function at power 1 to low the combustible consumption. When the temperature low
under the selected value the equipment restore the functioning on setting power. (ex pot.3)
nd
2 Modality, -STAND-BY ON-.
Once the appliance has reached one of the selected temperature, it start the modulation , and it
start to function at power 1 to low the combustible consumption, if even at power 1 the
temperature increase again, the equipment start the off cycle and it will signal on display "
ECO-STOP STAND BY".
MENU 06 (BEEP SOUND)
Within this Menu you can select the modality BEEP (buzzer).
OFF, no sound ON, sound in case of alarm.
MENU 07 (FIRST LOADING)
With this Menu you can set the continuous fuel load, this operation can only be effected
when the appliance on the display is evidencing "OFF". This menu is utilized to fill the screw
feeder when the appliance is new or in case of emptying of the pellet container.
MENU 08 (STOVE STATUS)
In this Menu you can find some informations about the working of the (info for technical
staff).
MENU 09 ( correct pellets)
Sometimes, changing type of pellet, there are so many types of wood pellet on the market, the
combustion of the appliance can be affected. A clear signal of an inefficient combustion is
given by the quantity of pellets into the burner basket during the normal working phase: too
much or too scarce. It is possible to make some small regulations on the combustion of the
appliance. Under the assumption that during the working phase the burner basket should be
full of pellet from ¼ to half of its capacity, whenever necessary, you can make some
adjustments following the below procedures:
IT IT IT IT- - - - GB GB- - - - FR FR- - - - ES
GB GB FR FR
59/140
ES mod. 540 VT – 540N VT
ES ES