Safety Warnings - Benman 160 GEN Notice Originale

ORIGINAL INSTRUCTIONS
ENGLISH

SAFETY WARNINGS

BEFORE USING THIS EQUIPMENT IT
IS RECOMMENDED TO READ THIS
INSTRUCTION MANUAL!
IN CASE OF MISSING READING, CAS-
ES OF FAILURE AND/OR DANGERS
FOR THE USER COULD HAPPEN!
THE UNIT CAN ONLY BE USED BY
PEOPLE WHO PERFECTLY KNOW
THE SPECIFIC SECURITY RULES!
This manual is an integrant part of the
equipment and it must be attached in
every displacement or resale.
It is user's responsibility to keep it
intact and in good conditions.
The manufacturer has the right to apply
modifies in every moment or without
any forewarning.
Every product is minded, designed and
produced in Italy in our sites.
This is guarantee of high quality and
reliability.
This equipment is designed solely for
industrial or professional use. As such,
only experienced or fully-trained
people should use the equipment. The
user and/or owner is responsible for
ensuring inexperienced personnel does
not have access to the equipment.
A workman must look after his tools
carefully ! Remember that any tool or
equipment can become a hazard if it is
not looked after properly. Equipment in
a state of discrepai or neglect can be
dangerous. If it does not operate
properly or overheats, the electricity
supply should be removed immediately
and the unit should be returned to the
supplier for repair.
Read this manual carefully before using
your Welder. You can then do a better
and safer job. By reading this manual
you will learn more about the possibil-
ities, limitations and potential dangers
of welding. Retain this manual for the
entire life of the equipment. It should
be kept within the operator's reach at
all times.
All equipment connected to electric
power supplies can be dangerous if the
manufacturers instructions are not
read and observed. Read, understand
and observe these safety instructions
to reduce the risk of death or injury
from electric shock. Ensure that even
bystanders are aware of, and
understand, the dangers that exist in
the welding area.
The safety information contained in
this manual is a guide to ensure you
are not subjected to unnecessary risks.
However, the operator must be compe-
tent and careful at all times.
The constructor declines all responsi-
bility for injury or damage caused by
inexperienced, improper or neglectful
use of its equipment.
Fires and explosions can seriously injure
or cause damage! Read, understand
and observe all safety warnings to
reduce the risk of death or injury from
fire or explosion. Pay particular atten-
tion to the fact that even bystanders
should be aware of, and understand,
the dangers existing in the welding
area. Remember that welding, by
nature, produces sparks, hot spatter,
molten metal drops, hot slag and hot
metal parts that can cause fires, can
burn skin and damage eyes.
Arc rays can damage your eyes and burn
your skin ! Read, understand and
observe all safety warnings to avoid
damage from arc rays. Pay particular
attention to the fact that even
bystanders should be aware of, and
understand, the dangers existing in the
welding area. Wear a protective mask
and make sure bystanders do the same.
Fumes, toxic gases and vapors can be
harmful! Read, understand and observe
all safety warnings to avoid harm from
toxic welding gases. Pay particular
attention to the fact that even
bystanders should be aware of, and
understand, the dangers.
10