Saci pumps EMOTION MT2-11A Manuel D'installation Et D'entretien page 46

Par. Description
DRY RUNNING ALARM
5.56
DELAY
5.57 BURST PIPE ALARM
5.58 VOLTAGE ALARM ACTIVE
5.59 MOTOR THERMISTOR TYPE
MOTOR THERMISTOR
5.60
TRIGGER LEVELL
5.61 PARAMETER LOCK
5.62 SET DATE AND TIME
STOP FREQUENCY SEARCH
5.63
WIZARD
5.64 FACTORY DEFAULT RESET
Par. Description
PROPORTIONAL
6.01
CONSTANT
6.02 INTEGRAL CONSTANT
6.04 SWITCHING FREQUENCY
STOP MANEUVER
6.05
FREQUENCY
SPEED OF STOP
6.06
MANEUVER
6.07 MODBUS ADDRESS
6.08 MODBUS BAUDRATE
6.09 MODBUS PARITY
6.10 ALARM LOG RESET
START-UP NUMBER LOG
6.11
RESET
To enter menu 6, a password is required (2468)
If installed on a borehole pump, it is reccomended to modify the 6.04 value (switching frequency) to minimum (2.5 kHz).
ATTENTION: Before modifying the menu 6 parameters, please contact our assistance service as, incorrect settings could cause improper functioning of the inverter and/
or pump damage.
Programming
Units
Default Min.
Sec 5 1
YES YES
YES YES
OFF
kohm 1 0,5
NO NO
NO NO
NO NO
NO NO
Programming
Units
Default Min.
100 0
100 0,1
kHz 7,7 2,5
Bar 0,1 0
1 1
1 1
kbps 19,2
0 0
NO NO
NO NO
Max.
Time from when the system calculates a low water level until the moment the alarm
99
is activated for this reason.
NO Parameter for enabling or disabling the detection of the broke pipe.
NO Parameter for enabling or disabling the alarm due to a power cut.
OFF
PTC By this parameter, select the type of motor thermistor available for motor protection.
NTC
99,9 By this parameter, set the trigger level of motor thermistor connected.
YES: Editing the values of the parameters is locked.
NO: Editing the values of the parameters is unlocked.
YES
To change this parameter from YES to NO, you must enter the password 1357 or
another password generated previously by the user.
When you change this parameters to "YES" this screen for editing the date and time
YES
will appear. Once editing is completed, the parameter returns to "NO".
If you change this parameter from "NO" to "YES" the stop frequency search wizard
YES
will be launched.
To reset the unit and leave it with the factory settings, change this parameter to
YES "YES" and after you have entered the code 1357 the unit will launch the start-up
wizard.
6. FINE TUNNING
Max.
999
999
16
0,5
64
250
4,8
9,6
19,2
2 0=even // 1=odd // 2=no parity
If you change this parameter from "NO" to "YES" you will reset the alarms log and
YES
the parameter automatically returns to "NO".
If you change this parameter from "NO" to "YES" you will reset the number of start-
YES
ups and the parameter automatically returns to "NO".
46
EN
Notes
Notes