Resetting To The Factory Default Settings; Further Information - Axis 214 PTZ Guide D'installation

Page 10 AXIS 214 Installation Guide
Accessing the AXIS 214 from the Internet
Once installed, your PTZ network camera is accessible on your local network (LAN). To access
the PTZ network camera from the Internet, network routers must be configured to allow
incoming traffic, which is usually done on a specific port. Please refer to the documentation
for your router for further instructions.
For more information on this and other topics, please visit the Axis Support Web at
www.axis.com/techsup

Resetting to the factory default settings

This will reset all parameters, including the IP address, to the Factory Default settings:
1. Disconnect power from the camera.
2. Press and hold the Reset button (on the underside of the camera) and reconnect power.
3. Keep the button pressed for 15 seconds, and then release it.
4. Re-install the camera using one of the methods described in this document.

Further information

For further information, please see the AXIS 214 User's Manual, which is available on the CD
included in this package. Updated versions can be obtained from www.axis.com