Troubleshooting
General
The power does not turn on.
Check that the AC power cord (mains lead) is connected securely.
•
The remote control does not function.
Point the remote control at the remote control sensor on the amplifier (page 4).
•
Remove any obstacles in the path between the remote control and the amplifier.
•
Replace both batteries in the remote control with new ones (page 9).
•
The DSEE HX indicator does not light even though the DSEE HX function is
turned on.
The DSEE HX function does not work depending on the input signal. While an unsupported input
•
signal is input, the DSEE HX indicator lights and turns off immediately when the DSEE HX function
is turned on. For details about the supported input signal, see page 28.
The amplifier turns off automatically.
If the menu setting item [AUTO STANDBY] is set to [ON], the amplifier turns off automatically
•
when you do not operate the amplifier in the silent state for about 20 minutes. The time until the
amplifier is turned off appears in the display window 1 minute before the amplifier is turned off.
Remove the AC power cord (mains lead) from the amplifier, then turn the amplifier on again.
•
Should any problem persist, consult your nearest Sony dealer.
AUTO STANDBY function does not work.
When connecting the digital cable for WALKMAN® (supplied), the AUTO STANDBY function does
•
not work.
Since the operation sound is played back depending on the computer settings, the AUTO
•
STANDBY function may not work.
[PROTECTOR] appears in the display window.
[PROTECTOR] appears if an abnormal current is carried on the headphone jack, or the temperature
•
in the amplifier rises abnormally. In this case, remove the headphone plug from the amplifier, then
press (power).
30
GB