Calling Up The Data Stored In Memory - Citizen CH-452 Manuel D'utilisation

CALLING UP THE DATA STORED IN MEMORY

HOW TO CALL UP THE DATA
• 90 measurement results can be stored in the
memory.
• Except for the case where the unit is engaged in
measurement, press "MEMORY" switch to call up
the values (measurement results) stored in memory
to the display.
* To erase all the data, remove the batteries. All the
stored data is erased.
• Press the "MEMORY" switch.
• "3A" indicating the average value appears
on the left section of the display. Then,
the average value, based on the last three
measurements, is displayed. ("3A" and the
average value do not appear if there are two
or fewer measurements stored in memory.)
• Press the "MEMORY" switch again. This
recalls and displays first the memory number
and then the last set of data stored.
- -
Eng 18