Logo Placement - Napoleon Bayfield GDS25N-1 Manuel D'installation Et D'opération

fi nishing
EN
B. Place the hole in the underside of log #2
onto the locating screw, on the left side of the
burner. The fi bre burner is formed to cradle the
centre of the log.
4.5

logo placement

Remove the backing from the logo and position onto the control door as shown.
26
W415-2347 / C / 09.21.20
1/2"
LOGO
1/2"
C. Place the hole in the underside of log #3 onto
the locating screw, on the right side of the
burner. The bottom branch of log #3 sits in
front of, and against, the right end of log #2.
D. Reinstall the glass door & front.