Publicité
Les langues disponibles
Les langues disponibles
User Manual
Introduction
Thank you for purchasing the LINDY Fibre Optic DVI-D Dual Link Extender!
This Fibre Optic Extender allows you to transmit DVI-D Dual Link signals up to maximum resolution of
2560x1600 at distances of up to 500m/1600 feet using an 8 core MPO multimode fibre cable. This cable
is available upon request from LINDY in custom made lengths.
Features
▪
Extends DVI-D signals up to 500m/ 1600 feet
▪
Suitable for use with Computer, Video Wall and Home Theatre equipment
▪
Uses a standard MPO fibre cable (not included)
▪
Auto power save mode
▪
Auto EDID programming and Self-EDID learning feature
▪
Auto Laser disable if DVI cable is removed
Specification
▪
DVI 2.0 Compatible
▪
Supports DVI-D Dual Link, resolutions up to 2560x1600@60Hz
▪
No HDTV / HDCP support
Package Contents
▪
LINDY Fibre Optic DVI-D Dual Link Extender: 1x Transmitter, 1x Receiver
▪
Multi-Country Power Adapter (5VDC) x 2
▪
This User Manual
Pre-Installation Remarks
The Extender will get warm up to 45 °C during operation!
Avoid touching it directly and install it with adequate ventilation!
Self-EDID learning procedure
The Fibre Optic DVI-D Extender has a default EDID pre-set table stored in the TX. If the display resolution
does meet this default EDID stored in transmitter module, you must perform the following EDID self-
learning procedure.
The EDID of a display can be stored in the TX by plugging it into the display.
1. Connect the power supply to the transmitter module (TX)
2. Switch on the monitor and connect the TX to the monitor
Press the Self-EDID button with a
narrow pin or paper clip
3. When
the
flashing, disconnect the TX and
install it in your regular extender
installation
green
LED
stops
CAUTION!
English
Publicité
