Low Battery Warning - ThermoPro TP-63A Manuel D'instructions

Channel 1 and you can always leave it unchanged unless
EN you have purchased more than 1 remote sensor.
4. Press and hold the ON/OFF button on the back of the
remote sensor for 2 seconds to turn on the remote sensor.
If done correctly, the temperature/humidity of the remote
sensor will appear on the base station.
5. If the RF indicator
sensor temperature is not displayed on the base station.
Press and hold the CHANNEL/SYNC button on the back of
the base station for 3-4 seconds until the RF indicator
flashes again to set it back in synchronization mode;
6. If you have additional remote sensors, repeat the above
steps to synchronize the additional remote sensors.
Please note the additional sensors should be set to a
different channel.
no longer flashes and the remote
-10-
7. If you have registered more than one sensor, press the
CHANNEL/SYNC button on the base station to select the
remote channel you want displayed permanently on the
base station. If you wish to cycle through all the channels,
press the CHANNEL/SYNC button until you observe a
circular arrow on the base station LCD display under
the channel number.

Low Battery Warning

If the battery power (base station or remote sensor) is low,
there will be low battery icon showing on the base station
display.
If the low battery icon for base station appears, please
replace the batteries with new batteries.
-11-
EN