Medium
(
), Beef Well Done (
programmed
doneness temperature setting for each meat type is
recommended by
USDA (U.S. Department of Agriculture). In Timer mode,
press the S/S
button to begin the count-down or count-up timer. Press the
EN
S/S button to
pause or restart the timer.
9. Flip-out Counter Top Stand: Allows user to place device on counter for
easy viewing.
10. Magnet: Allows user to stick device to a metal surface. For example, a
refrigerator.
11. Battery Compartment: Hold one AAA battery.
12. Backlight: Press any key to activate the back light of the screen. If there
is no key operation for 10 seconds, the backlight will be automatically
turned off. When there is alarm sound, the backlight will be turned on and
flashing.
Note: This unit is designed to remotely monitor cooking progress. Do not
remove the probes during cooking. The internal temperature will be displayed
on the unit outside of the oven.
Features And Specifications
1. Programmable alert with preset temperatures recommended by USDA for
specific foods.
2. Dual stainless-steel probes with steel mesh cable to measure and monitor
temperatures of two pieces of meat or two sections of the same large piece
of meat simultaneously.
3. Temperature range of probe: 14˚F to 572˚F (-10˚C to 300˚C).
4. Temperature tolerance of internal food reading:+/-1.8˚F (+/-1.0˚C).
), and User-Defined (
). The pre-
-5-
5. 99-hour and 59-minute countdown timer and count up timer.
6. Temperature readings in ˚F or ˚C.
7. Flip-out counter top stand and magnet.
8. Uses one AAA battery (included).
* If probe is not inserted into food and put directly inside the oven, the
temperature reading of oven heat above 200˚F (93˚C) will be accurate to
within 2˚F to 5˚F (1.1˚C to 2.7˚C).
Battery Installation/Set Up
Slide open the battery compartment door at the back of the unit.
Insert one (1) AAA battery according to the polarity markings.
Replace the battery compartment door.
Remove the printed vinyl label from the LCD screen.
Important Notes/Warning
This product is not for use in microwave ovens.
Keep out of reach of children.
Do not touch hot probe or wire with bare hands or just after cooking.
Always wear a heat-resistant glove.
Do not expose probe directly to flame. Doing so will cause wire to
deteriorate.
When not in use, slide the mode selector switch to the OFF position
to conserve the battery.
Be sure to use a good quality alkaline battery and replace it often. A weak
battery will cause the unit to lose accuracy. Always dispose of exhausted
batteries safely.
-6-
EN