ThermoPro TP-63A Manuel D'instructions page 10

7. Temperature tolerance: +/- 2.0 °F (+/- 1.1 °C).
EN
8. Humidity tolerance: ±2% from 30% to 80%; ±3% below
30% and above 80%.
9. Power: 2 X AAA 1.5V for base unit and 18650 lithium
battery 3.7V for remote sensor.
FCC STATEMENT OF COMPLIANCE
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not
expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
-18-
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of more
of the following measures:
- Reorient or relocate the receiving antenna.
-19-
EN