Operation - Zanussi ZFC51400WA Notice D'utilisation

Operation

Control panel
1
Switching on
1. Insert the plug into the wall socket.
2. Turn the Temperature Regulator to the Full
Loaded position and let the appliance run
for 24 hours to allow the correct
temperature to be reached before placing
food inside.
The pilot light will light up.
3. Adjust the Temperature Regulator
according to the quantity of the stored
foods.
Switching off
Turn the Temperature regulator to the OFF
position.
Temperature regulation
The temperature within the appliance is
controlled by the Temperature Regulator
situated on the control panel.
To operate the appliance, proceed as follows:
• to obtain the minimum coldness, turn the
Temperature Regulator toward lower
settings.
www.zanussi.com
2 3
A
B
C
Temperature regulator
1
Pilot light
2
High temperature alarm light
3
A) Temperature Regulator
B) Half Loaded position
C) Full Loaded position
• to obtain the maximum coldness. turn the
Temperature Regulator toward higher
settings.
In case of freezing less food
volumes, the Half Loaded setting is
the most suitable. In case of freezing
much food volumes, the Full Loaded
setting is the most suitable.
High temperature alarm
An increase in the temperature in the freezer
(for example due to an power failure) is
indicated by switching on of the Alarm light
During the alarm phase, don't place food inside
the freezer.
When normal conditions are restored the Alarm
light will switch off automatically.
5