Safety Instructions - Pentair Raychem T-M-20-S Mode D'emploi

non-hazarDous surFace sensing
ThermosTaT wiTh limiTer
The T-M-20-S is used for temperature control of electrical heaters
in industrial plants. It is suitable for simple applications, such
as frost protection and temperature maintenance at different
temperature ranges. Because of its high breaking capacity of 2300
VA it is also suitable for switching the heater directly up to this
power. A direct connection to heating-tapes or heating-cables is
possible.
The thermostat T-M-20-S consists of one temperature controller
and one additional safety temperature limiter.
The bulb and capillary tube thermostat can be used alternatively as
air- or clip-on thermostat.
The thermostat and limiter are mounted in a weather-proof
polyester enclosure, which is IP 65 rated.

1. safety instructions

The device meets the VDE 0631 and VDE 0700 regulations. It is
necessary to observe the following rules:
attention!
The device is an electric equipment.
installation, maintenance and repair should only be carried out by
qualified personnel.
Opening of the device:
Before opening the cover, the device must be isolated from any
supply-terminals!
Defects and damage:
If a safe operation is no longer possible, the device must be
disconnected and protected against accidental use.
This is the case when
• the device has visible damage from storage and transport
• the device no longer works
4