Stadler Form Julia Mode D'emploi page 7

such that a person in the bath tub cannot touch the appliance.
• Do not place the appliance near a heat source. Do not subject the power
cord to direct heat (such as a heated hotplate, open flames, hot iron sole
plates or heaters for example). Protect power cords from oil.
• See to it that the appliance is properly positioned to ensure a high stabil-
ity during its operation and make sure that no one can trip over the power
cord.
• The appliance is not splash-proof.
• For indoor use only.
• Do not store the appliance outdoors.
• Store the appliance in a dry place inaccessible to children (pack the ap-
pliance).
• If the power cord is damaged, it must be replaced by the manufacturer
or a repair shop authorized by the manufacturer or by similarly qualified
persons in order to avoid a hazard.
• Only use fragrances, aromas or essential oils that do NOT contain alcohol.
Alcohol can damage the appliance. Appliances that are damaged by such
additives are not covered by the warranty.
Setting up / operation
1. Place Julia at the desired location on a flat surface. Connect the network
adapter (1) to the device (2) and plug the adapter into a suitable socket.
2. Lift off the upper part (3) and the mist outlet/lid (4) in order to fill with
water and fragrances.
3. Fill the water container (5) up to the maximum mark (MAX) (6) with wa-
ter. No water may enter the air outlet opening (15). This will damage the
appliance and will void any claim to the warranty. Important: please do
not carry Julia around whilst she is filled with water. The water could
run into the electronics.
4. Add 2–3 drops of your favourite liquid fragrance directly into the water.
It is not necessary to mix them as the ultrasonic membrane (7) does
this for you. Only use fragrances, aromas or essential oils that do NOT
contain alcohol.
5. Put the lid (4) and the upper part (3) back on the water container (5). In
doing so, make sure that the lid and the upper part are correctly posi-
tioned (lid: fit the rear cutout onto the lower part; upper part: fit the
opening in the middle of the indentation onto the guide bar in the water
container).
6. Then switch Julia on by pressing the on/off button (8). Important: Only
switch Julia on if you have placed both the mist outlet/lid (4) and the
upper part (3) on the water container (5). Once Julia has been switched
on, the LEDs to the right of the on/off button light up. If this does not
happen, check whether there is sufficient water in the device or check
whether the adapter has been connected to the power supply. With a
full water container (up to the MAX mark), the runtime is approx. 18 h
and 54 h in interval mode. The appliance switches off automatically
when the water container is empty
7. The output level can be adjusted by re-pressing the on/off button (8) on
the front of the device: two LEDs for the higher level and one LED for
the lower level (9).
8. Interval mode makes it possible for you to run the aroma diffuser for
approx. 54 h at the output level without having to refill it again. Press