Homelite HBP-30 Manuel D'utilisation page 19

GB
F D E
OPERATION
Start the blower. Refer to "Starting and Stopping"
■
earlier in this manual.
Put on the blower again. The unit should be operated
■
from the right side (Fig. 10).
To keep from scattering debris, blow around the outer
■
edges of a debris pile. Never blow directly into the
center of a pile.
To reduce sound levels, limit the number of pieces of
■
equipment used at any one time.
Operate blower at the lowest possible throttle speed
■
to do the job.
Check your equipment before operation, especially
■
the muffler, air intakes, and air filters.
Use rakes and brooms to loosen debris before
■
blowing. In dusty conditions, slightly dampen surfaces
when water is available.
Conserve water by using power blowers instead of
■
hoses for many lawn and garden applications,
including areas such as gutters, screens, patios,
grills, porches, and gardens.
Watch out for children, pets, open windows, or freshly
■
washed cars, and blow debris safely away.
Use the the full blower nozzle extension so the air
■
stream can work close to the ground.
After using blowers or other equipment, CLEAN UP!
■
Dispose of debris properly.
MAINTENANCE
WARNING
When servicing, use only identical Homelite
replacement parts. Use of any other parts may
create a hazard or cause product damage
WARNING
Always wear safety goggles or safety glasses
with side shields during power tool operation or
when blowing dust. If operation is dusty,
also wear a dust mask.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
I P NL S DK N FIN GR HU CZ RU
English
LUBRICATION
All of the bearings in this tool are lubricated with a
sufficient amount of high grade lubricant for the life of the
unit under normal operating conditions. Therefore,
no further lubrication is required.
REPLACING AND CLEANING THE AIR FILTER
(Fig. 5)
For proper performance and long life, keep the air filter
(28) clean.
Push down on the latch of the air filter cover; carefully
■
pull the top of the air filter cover so it pivots away from
the base.
Remove the air filter and clean it in warm soapy
■
water. Rinse and let dry completely.
Reinstall the air filter into the air filter base.
■
Pivot the cover back in place. Push the latch back
■
into the slot and ensure the cover is locked in place.
NOTE: The filter should be replaced annually for best
performance.
SPARK ARRESTOR
The muffler is equipped with a spark arrestor screen
inside muffler body. After extended use the screen can
become dirty and may need to have the muffler replaced
by an authorized servicing dealer.
CLEANING THE EXHAUST PORT AND
MUFLER
Depending on the type of fuel used, the type and amount
of oil used, and/or your operating conditions, the exhaust
port and muffler may become blocked with carbon
deposits. If you notice low power from the blower, have a
qualified service technician check the exhaust port and
muffler for carbon deposits. Removing the carbon
deposits should restore performance to the blower.
14
RO PL SLO HR TR EST LT
WARNING
Do not at any time let brake fluids, gasoline,
petroleumbased products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may
result in serious personal injury.
WARNING
Never run the blower without the spark arrestor
in place. Failure to do so could result in a fire that
could cause serious personal injury.
LV SK BG