Hantech A020BA Serie Mode D'emploi page 20

Problems Reasons
There is no electricity.
The overflow indicator
displays
"FL".
The ambient temperature is
too
The air
low or too high
conditioning
In
does not
room
work.
temperature is lower than the
set temperature; in heating
mode, the room temperature
is
temperature.
In dehumidification mode,
the ambient temperature is
low.
There is direct sunlight.
The cooling Doors or windows are open;
effect is not
there
good
are a lot of people; or in
cooling
mode, there are other sources
The filter screen is dirty.
of
The air inlet or outlet is
heat.
blocked.
The air conditioning is not
Big Noise
placed
on a flat surface.
compressor
Overheat protection starts.
does not
work.
The distance
machine and the remote
control is too far.
The remote
control does
not work.
cooling mode,
higher than the
between
Solutions
Turn it on after connecting it to a
socket
with electricity.
Discharge the water inside.
Recommend to use the machine
in at
the temperature of 7-35 ℃ (44-95
℉).
the
Change the set temperature.
set
The machine is placed in a room with
an
ambient temperature of greater
than 17
Pull the Curtain.
℃ (62 ℉).
Close doors and windows, and add
new
air conditioning.
Clean or replace the filter screen.
Clear obstructions.
Put the air conditioning on a flat
and
hard place (to reduce noise).
Wait for 3 minutes until the
temperature
is lowered, and
the machine.
the
Let the remote control get close to
the air conditioning, and make sure
that the remote control directly faces
to the direction of the remote control
then restart