Nail; Black 9/16" Large Head Screw - Sauder Cannery Bridge Serie Instructions De Montage

Step 12
Carefully turn your unit over onto its front edges. Fasten the
å
BASE (N) to the BOTTOM (G2). Use three BLACK 9/16" LARGE
HEAD SCREWS (1S) through the LARGE METAL BRACKETS
and into the BASE.
NOTE: You may need help from another person to help get your
å
back centered on the unit.
Unfold the BACK (I) and lay it over your unit.
å
Make equal margins along the top and bottom edges of the
å
BACK (I). Then, make equal margins along the side edges of
the BACK (I). Push on opposite corners of your unit if needed to
make it "square".
Fasten the BACK (I) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over the
å
UPRIGHTS (C, D, and E) and SHELF (H2).
These holes must line up over the
UPRIGHTS (C, D, and E) and SHELF (H2).

BLACK 9/16" LARGE HEAD SCREW

(3 used for the BASE)
Page 16
G2
N
1S
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
424192
1N

NAIL

(82 used for the BACK)
I
www.sauder.com/services