Sauder Cannery Bridge Serie Instructions De Montage page 7

Step 3
Turn the ENDS (A and B) over.
å
Turn eight BLACK 9/16" FLAT HEAD SCREWS (32S) into the ENDS (A and B) until the shoulders of the SCREWS rest on
å
the surfaces of the ENDS.
Slide the MOLDINGS (Q and U) onto the ENDS (A and B). Line up the grooves in the MOLDINGS over the heads of the
å
SCREWS in the ENDS.
NOTE: The END MOLDINGS (U) are wider than the UPPER END MOLDINGS (Q).
å
NOTE: Be sure to place the MOLDINGS in the exact locations shown below.
å
BLACK 9/16" FLAT HEAD SCREW
Q
These edges
should be even.
www.sauder.com/services
32S
B
Edge with smaller holes
These edges
should be even.
BLACK 9/16" FLAT HEAD SCREW
(8 used in this step)
Q
These edges
should be even.
A
U
32S
424192
Edge with smaller holes
Shoulder
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
U
Page 7