Nail - Sauder 412320 Mode D'emploi

Step 16
Carefully turn your unit over onto its front edges. Lay the BACK (K)
å
over your unit.
Make equal margins along the long edges of the BACK (K). Be
å
sure the back is against the bottom surface of the TOP (E). Push
on opposite corners of your unit if needed to make it "square".
Fasten the BACK (K) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the SHELF (J).
NOTE: Perforations have been provided for access through the
å
BACK. Carefully cut out the holes needed.
Page 20
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Edge without holes
412320
1N

NAIL

(22 used in this step)
These holes must line
E
up over the SHELF (J).
K
www.sauder.com/services